How can I remove the water ring around my fish's bowl? - gilbert bowling alley
My betta get your dirty dish, and if not cleaned every week when I get a ring. I have tried cleaning with warm water and a paper towel, but without success. Is there a way to purify himself, that the ring will not hurt my fish? I know that no chemicals to kill, without a doubt. [[PS I have my fish, Gilbert, for almost three years, so try to be very careful with him because I love it]]
Sunday, January 10, 2010
Gilbert Bowling Alley How Can I Remove The Water Ring Around My Fish's Bowl?
10 comments:
One word - vinegar. Total intensity was spread directly on the ring or in the water line. Course for a while, then rub. Rinse with water after washing.
Of course, no fish on the plate. Gilbert wants to fish in the spa day or something. Enjoy clean your house when you return.
Cleaning with a brush or might buy in a store the fish
Cleaning with a brush or might buy in a store the fish
I have a Betta fish, I rinse the bowl with the vinegar after the transfer Betta in a different container, the ring away.make rinse the containers underground well before the fish in
My mother uses the money for us. I hope this helps: D
Gilbert you to another clean container (a pot, a cup or pot), with the same water. Drain and rinse the tank. The use of a paste of baking soda and water. Rub the stain with it, must be thoroughly cleaned, then rinsed before return to Gilbert and return water dried in his aquarium.
Vinegar.
In general, the ring comes with warm water and rub with salt. If it does not rub with vinegar. Sometimes part of the ring is on the glass caused by chemical substances that make the ring engraved. If thaat is the case, nothing goes.
MM
Try hydrogen peroxide. Its safe, clean with.
There is no simple way to do this without affecting the fish! I bought the cleaner "safe and easy PetSmart. It comes in a spray bottle and a package of wet wipes. This works well, but not much. Because white is the accumulation of lime, you can go to the DIY store and buy a router, not the angle at which the blade is triangular, but the blade flat. The study on the use of a vacuum cleaner, which I mentioned, or the aquarium water and wet the structure. Then, in small areas, scratching with the blade in a single, moving forward, not back and forth. If it is turned off, then keep doing that once a month. Good luck! steve
Post a Comment